Temperature

pH value

Friday, December 11, 2015

Treatment Objective





Treatment

To create an aquatic environment similar to the one of the Baltic Sea, the required equipment was as follows:

1 Aquarium - this acts as the boundary of the Baltic Sea. Aquarium used was found in the Environmental Laboratory at the Myyrmäki campus.

2 Air pump - in the Baltic Sea, the tides and constant movement of currents is very important. Horizontally, it ensures that heat and salt is distributed throughout the sea and vertically, it is crucial for the exchange of heat and gases (such as CO2) between the higher and lower levels of the sea. The same movement is important in the aquarium therefore it is essential to use an air pump. The air pump was bought from Akvaariokeskus. 

3 Pebbles - although the Baltic Sea has rocks at the bottom, the reason for including pebbles in our aquarium was to keep the plants fixed to the bottom of the aquarium. 

4 Water - the water used in the aquarium was water from the Baltic Sea. The water was collected from the shore, where the water is not as salty as in deeper parts of the sea. This is an important point when looking at the results of the project.
5 Vegetation - the plants are a key component to the system therefore plants that would have the best chance of survival and treatment abilities were chosen. Appendix 2 7 (27) The selected species have been previously used in brackish water aquariums or ponds to lower nutrient levels. Aegagrophila linnaei, also known as ‘Marimo’, was chosen experimentally for this particular project. A detailed analysis of each species is written in the Economic Evaluation section. 



No comments:

Post a Comment